锟斤拷If the reading is not within the specified range, replace the Q8 control solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly replacement,
setup, and programming.
2ML70 - Automatic Transmission
DTC P2728-P2730
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P2728
- Pressure Control (PC) Solenoid 5 System Performance
DTC P2729
- Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage
DTC P2730
- Pressure Control (PC) Solenoid 5 Control Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The clutch pressure control solenoid 5 is part of the control solenoid valve assembly and is not serviced separately. The transmission control
module supplies 12 volts to the PC solenoid 5 through the high side driver 1 circuit. The transmission control module controls the clutch pressure
control solenoid 5 through the clutch pressure control solenoid 5 control circuit. The normally low clutch pressure control solenoid 5 flows fluid to
the actuator feed limit valve when commanded ON and exhausts fluid when commanded OFF. The clutch pressure control solenoid 5 regulates the
transmission fluid pressure from the auxiliary transmission fluid pump in order to maintain transmission fluid pressure during electric only and
auto-stop modes.
Conditions for Running the DTC
* The engine run time is greater than 5 seconds.
* The vehicle speed is less than 200 km/h (124 mph) for 5 seconds.
* The system voltage is 11-18 V.
Conditions for Setting the DTC
P2728
The transmission control module detects an internal electrical performance malfunction of the clutch pressure control solenoid 5 control circuit
when the actual pressure does not equal the commanded pressure for 5 seconds.
