2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1442
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0602
- Control Module Not Programmed
DTC P0603
- Control Module Long Term Memory Reset
DTC P0604
- Control Module Random Access Memory Performance
DTC P0605
- Control Module Programming Read Only Memory Performance
DTC P0606
- Control Module Processor Performance
DTC P0610
- Control Module Vehicle Options Incorrect
DTC P0614
- Engine Control Module/Transmission Control Module Programming Not Plausible
DTC P0630
- VIN Not Programmed or Mismatched - Engine Control Module (ECM)
DTC P06D1
- Control Module Ignition Coil System Circuitry Performance
DTC P160D
- Incorrect Engine Calibration Detected
DTC P160E
- Engine Calibration Monitoring Not Programmed
DTC P161C
- Tire Size Not Programmed
DTC P2610
- Control Module Ignition Off Timer Performance
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if
the ECM is not programmed, or is programmed incorrectly.
Conditions for Running the DTC
P0602, P0603, P0604, P0605, P0610, P0614, P0630, P160D, P160E, P161C
These DTCs run continuously when the ignition is ON.
P0606
DTC P0606 runs continuously when the engine speed is greater than 1,200 RPM.
P06D1
* The engine is running.
* The engine speed is less than 5,000 RPM.
* The battery voltage is between 10-18 V.
* DTC P06D1 runs continuously when the above conditions are met.
P2610
DTC P2610 runs continuously when the engine speed is greater than 240 RPM.
