2010 Cadillac Truck SRX FWD V6-3.0L Page 763
Conditions for Running the DTC
Ignition OFF, ACCESSORY, or RUN mode.
Conditions for Setting the DTC
The parking brake control module has an internal counter which keeps track of dynamic applies. When the counter reaches the threshold value this
DTC will set.
Action Taken When the DTC Sets
A message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The parking brake control module clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
* Adjust or replace the park brake pads.
Reference Information
Schematic Reference
Park Brake System Schematics (See: Brakes and Traction Control/Parking Brake System/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Electronic Parking Brake Control Module Description (See: Brakes and Traction Control/Parking Brake System/Parking Brake Control
Module/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Verify DTC C028D is not set.
If DTC is set, replace the rear brake pads and perform the Parking Brake Calibration procedure.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for parking brake control module replacement, setup, and
programming.
C028F
DTC C028F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
