Saturday, January 1, 2022

Disclaimer2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-08-44-004B Date: 120626

Disclaimer2010 Cadillac Truck SRX AWD V6-3.0L Technical Service Bulletin # 10-08-44-004B Date: 120626



2010 Cadillac Truck SRX AWD V6-3.0L Page 34



Audio - Information On USB/Multimedia Player



INFORMATION



Bulletin No.: 10-08-44-004B



Date: June 26, 2012



Subject: Information on USB Command and Control Multimedia Player Interface/List of Supported Devices



Models:



2011-2013 Buick Regal



2010-2013 Cadillac SRX



2009-2013 Chevrolet Avalanche, Silverado, Suburban, Tahoe



2011-2013 Chevrolet Cruze, Equinox, Volt



2010-2013 GMC Terrain



All Equipped with Convenience and Connectivity Package (RPOs UFV, UUK, UUL, UYS)



Supercede:



This bulletin is being revised to add the 2012-2013 model years. Please discard Corporate Bulletin Number 10-08-44-004A (Section 08 - Body and



Accessories).



USB Radio and MP3 Functionality



The universal serial bus (USB) will be a USB 2.0 port on the radio faceplate, on the IP or in the center console. This interface will give the



customer the additional functionality of iPod(R)/MP3 command and control. Customers now have full radio control of the iPod/MP3 audio files via



the USB cable. A single USB connection allows digital audio transferring from the iPod to the radio. The iPod will be charging while connected to



the radio. The customer will also have playback capability with a USB memory stick (only MP3 and WMA files).



Note



Not all memory sticks are supported.



Note



Video from the iPod is NOT capable of being transferred to a Navigation radio display.



Problems with iPod Not Connecting



If the infotainment system does not operate properly when using a device connected through the USB port, this may be due to an incompatible



media device.



Important



DO NOT replace the radio or multimedia interface module due to a customer device incompatibility issue.



Verify the customer's media device is validated for this system using the list below. If the customer's device is a validated device for this system,



follow the SI diagnostic procedure to isolate the fault. If the customer's device is not on the validated device list, explain to the customer that their



particular unit is not compatible with the system.



Troubleshooting Tips for iPod Devices



1. Verify the version of the iPod/MP3 to confirm that it is supported.



2. Unplug and re-insert the iPod to verify the customer concern.



3. Verify the battery charge of the iPod. A low battery condition on the iPod may not allow it to connect to the radio. The iPod may need to be



charged before it can be controlled by the radio.



4. If the customer receives a "Device Not Supported" message on their radio or is having general iPod/MP3 connection issues (and they have a



supported device), they may need to reset their iPod. To reset the iPod:



- For the iPod nano(R) and iPod classic(R), toggle the Hold switch on and off (slide it to Hold, then turn it off again). Press and hold the



Menu and Center (Select) buttons simultaneously until the Apple(R) logo appears, about 6 to 8 seconds. You may need to repeat this step.



- For the iPod touch(R) and iPhone(R): Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the



slider.



5. For iPod touch and iPhone: To obtain full use capabilities of their device, it needs to be fully powered up when connecting to the USB port.



2010 Cadillac Truck SRX AWD V6-3.0L Page 35



If these devices are fully powered down or in "sleep" mode, please advise the customer to press and hold the Sleep/Wake button on the top of



the device for a few seconds and if an unlock pass code is required, to enter the pass code as well as slide the lower "Unlock" slider.



6. Have the customer inspect their cable for quality.



- Aftermarket cables can wear from use. The customer may need to purchase a new USB cable.



- Verify that cable extensions are not present. The extra capacitance may cause too large a signal drop for the iPod to communicate with the



radio.



7. If the customer receives a "Device Not Supported" message on their radio with an iPod connected (and they have a supported device), the



customer may need to download the latest firmware from the Apple website (Please visit www.apple.com for more information).



Validated Apple Device - Both Charge/Support Digital Audio



Important



None of these device lists below support video.



Important



Not all iPhone functions are fully supported.



For further information on identifying iPod models, please visit http://support.apple.com/kb/HT1353.



Important



These devices (and additional MP3 players) may be capable of connecting to the other USB options by internally setting the MP3 device to



mass storage class (MSC) mode. In this mode, the USB port will see the device as a flash drive. Please have the customer refer to their MP3



device manual on how to set the device to MSC. If the device is not able to be set to MSC, the customer must use the AUX jack.



Note



MTP mode must be used in order to transfer ANY Digital Rights Management (DRM) protected content.



2010 Cadillac Truck SRX AWD V6-3.0L Page 36



Non-Validated Apple Device



Specifications



2010 Cadillac Truck SRX AWD V6-3.0L Page 37



Playback Operation (X = Supported; - = Not Supported)



2010 Cadillac Truck SRX AWD V6-3.0L Page 38



Other USB Device Supported Requirements (X = Supported; - = Not Supported)