2010 Cadillac Truck SRX FWD V6-3.0L Page 1959
* The ignition voltage is greater than 6 volts.
* The ECM is not commanding reduced power.
* The DTCs run continuously when the above conditions are met.
P2138
* DTCs P06A3, P0697, P2122, P2123, P2127, or P2128 are not set.
* The ignition is ON or the engine is operating.
* The ignition voltage is greater than 6 volts.
* The ECM is not commanding reduced power.
* The DTC runs continuously when the above conditions are met.
Conditions for Setting the DTC
P2122
The ECM detects that the APP sensor 1 voltage is less than 0.46 volt for less than 1 s.
P2123
The ECM detects that the APP sensor 1 voltage is greater than 4.7 volts for less than 1 s.
P2127
The ECM detects that the APP sensor 2 voltage is less than 0.32 volt for less than 1 s.
P2128
The ECM detects that the APP sensor 2 voltage is greater than 2.6 volts for less than 1 s.
P2138
The ECM detects that APP sensor 1 and APP sensor 2 disagree greater than 10 percent for less than 1 s.
OR
The ECM detects that both APP sensor 1 and APP sensor 2 are 5 percent greater than the learned minimum position for less than 1 s.
Action Taken When the DTC Sets
* DTCs P2122, P2123, P2127, P2128, and P2138 are Type A DTCs.
* The ECM commands the TAC system to operate in a Reduced Engine Power mode.
Conditions for Clearing the DTC
DTCs P2122, P2123, P2127, P2128, and P2138 are Type A DTCs.
Diagnostic Aids
* If a shared 5-volt reference circuit is shorted to ground or shorted to a voltage, other 5-volt reference circuits may be affected.
* The scan tool 5 volt reference parameter should display between 4.8-5.2 volts.
* A high resistance condition on the accelerator pedal position circuits could cause a DTC to set.
Reference Information
Schematic Reference
Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics
(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Throttle Actuator Control (TAC) System Description (See: Powertrain Management/Computers and Control Systems/Description and
Operation/Throttle Actuator Control (TAC) System Description)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
