2010 Cadillac Truck SRX FWD V6-3.0L Page 1126
Sensor parameter is greater than 127 kPa (18.4 psi).
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K20 ECM.
6. If the circuits test normal, test or replace the B74 MAP sensor.
Component Testing
Note: You must perform the Circuit/System Testing in order to verify the integrity of the MAP sensor circuits before proceeding with the
Component Testing.
Erratic Signal Test
1. Ignition OFF, remove the B74 MAP sensor.
2. Install a 3 A fused jumper wire between the 5 V reference circuit terminal 1 and the corresponding terminal of the B74 MAP sensor.
3. Install a jumper wire between the low reference circuit terminal 2 of the B74 MAP sensor and ground.
4. Install a jumper wire at terminal 3 of the B74 MAP sensor.
5. Connect a DMM between the jumper wire from terminal 3 of the B74 MAP sensor and ground.
6. Ignition ON, with the J 23738-A - Mityvac or the J 35555 - Metal Mityvac , slowly apply vacuum to the sensor while observing the voltage
on the DMM. The voltage should vary between 0-5 V without any spikes or dropouts.
瀚慖f the voltage reading is erratic, replace the B74 MAP sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0108
DTC P0107 or P0108 (LF1)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provide an overview of each diagnostic category.
DTC Descriptors
DTC P0107
- Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage
DTC P0108
- Manifold Absolute Pressure (MAP) Sensor Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
