2010 Cadillac Truck SRX FWD V6-3.0L Page 1669
Conditions for Running the DTC
P0711
* The ignition voltage is 10.2-15.5 V.
* The engine speed is greater than 400 RPM for 2 s.
* TCM communication is normal.
* DTCs P0712, P0713 are not set.
* The transmission is not in emergency mode.
* The engine speed is greater than 400 RPM for 10 min.
* Vehicle speed was 40 km/h (25 MPH) or greater at once.
P0712
* The ignition voltage is 10.2-15.5 V.
* The engine speed is greater than 400 RPM for 2 s.
* The transmission is not in emergency mode.
* Driving in D range.
* TCM communication is normal.
P0713
* The ignition voltage is 10.2-15.5 V.
* The engine speed is greater than 400 RPM for 2 s.
* The transmission is not in emergency mode.
* Driving in D range.
* Driving time is more than 10 min.
* TCM communication is normal.
Conditions for Setting the DTC
P0711
The automatic transmission fluid temperature is less than 20掳C (36掳F) after 10 min driving or more.
P0712
The automatic transmission fluid temperature is more than 200掳C (473掳F) for 10 s or more after consecutive 30 times.
P0713
The automatic transmission fluid temperature is lower than -43掳C (-45掳F) for 1 s or more after consecutive 12 times.
Action Taken When the DTC Sets
* The TCM will default the transmission oil temperature to 80掳C (353掳F).
* No lock-up slip control
* No neutral control
* No self learning control
Conditions for Clearing the DTC
P0711, P0712, and P0713
These are Type C DTCs.
P0712, P0713
The automatic transmission fluid temperature is between 20-150掳C (68-302掳F) for 10 s or more.
Diagnostic Aids
A correct transmission fluid level is required for a proper function. The automatic transmission fluid temperature sensor is located inside the
transmission at the valve body. To ensure that the shown oil temperature is correct, measure the oil temperature with an external thermometer.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical
Diagrams)
Connector End View Reference
