2010 Cadillac CTS Sedan AWD V6-3.6L Page 379
Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
B1433
DTC B1433
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1433 00
- Ignition Switched Power Relay 2 Circuit
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) controls the RUN relay through the run relay coil control circuit by applying voltage to the coil side of the relay.
The RUN relay is energized when any of the following conditions are true:
* Ignition Switch is in ACC or RUN.
* The vehicle was remote started.
* The vehicle is in retained accessory power (RAP) mode.
Conditions for Running the DTC
* The system voltage is between 9-16 volts.
* The DTC can only set when the output is actively being requested by the module.
Conditions for Setting the DTC
The DTC will set only when the module requests the output and there is a short to ground in the run relay coil control circuit.
Action Taken When the DTC Sets
The module output driver will be shut down and not supply voltage to the circuit.
Conditions for Clearing the DTC
* The current DTC will clear when the module request for the output is removed or the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
Diagnostic Aids
A short to voltage may cause some accessories to operate with the ignition key out and cause a low battery after extended non vehicle use.
Reference Information
Schematic Reference
* Body Control System Schematics (See: Body and Frame/Body Control Systems/Diagrams/Electrical Diagrams)
* Power Distribution Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Power Distribution Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
