2010 Cadillac CTS Sedan AWD V6-3.6L Page 525
Circuit Description
The memory seat module (MSM) receives voltage inputs from the tilt/telescope switch based on the position of the switch. The MSM then supplies
battery voltage and a ground to the tilt or telescope motor control circuits depending on which direction of movement is requested.
Conditions for Running the DTC
The ignition ON.
Conditions for Setting the DTC
The MSM detects a tilt or telescope switch input for more than 30 consecutive seconds after the tilt or telescope motor movement has stopped.
Action Taken When the DTC Sets
* The tilt or telescope motor will be deactivated.
* Memory recall functions will be disabled.
Conditions for Clearing the DTC
* A current DTC will clear when the failed switch input is no longer active.
* A history DTC will clear after 100 ignition cycles.
Diagnostic Aids
An intermittently stuck tilt or telescope switch may cause a DTC to set.
Reference Information
Schematic Reference
Tilt/Telescoping Steering Column Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Tilt/Telescoping Steering Column
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information
Circuit/System Verification
Ignition ON, view the appropriate scan tool Tilt or Telescope Switch parameter while cycling the appropriate switch between states.The parameter
should change between Active and Inactive.
Circuit/System Testing
