2010 Cadillac CTS Sedan AWD V6-3.6L Page 704
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition ON, verify that DTCs U1826, or U1827 are not set.
瀚慖f any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle)
2. Ignition OFF, disconnect the yaw/lateral acceleration sensor connector.
3. Ignition OFF wait 1 minute, test for less than 10 ohms between the low reference circuit terminal 6 and ground.
瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuits test normal, replace the EBCM.
4. Ignition ON, test for B+ between the ignition circuit terminal 1 and ground.
瀚慖f less than the specified value, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the EBCM.
5. If all circuits test normal, replace the yaw/lateral accelerometer sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction
Control Systems/Yaw Rate Sensor/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming
C0293
DTC C0293
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provide an overview of each diagnostic category.
DTC Descriptors
DTC C0293 01
- Park Brake Switch Control Short to Battery
DTC C0293 06
- Park Brake Switch Control Low Voltage/Open
DTC C0293 08
- Park Brake Switch Control Performance-Signal Invalid
Circuit/System Description
The electric parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electric parking brake
control module also contains the logic for applying and releasing the parking brake when commanded by the electric parking brake switch. The
electric parking brake module will perform diagnostics on the electric parking brake switch and its wiring harness to verify it is functioning
properly. When the electric parking brake control module receives a signal from the switch the internal circuit board temperature is checked to
verify it is within operating range before the control module performs the requested operation.
