2010 Cadillac CTS Sedan AWD V6-3.6L Page 279
Circuit/System Verification
1. With a scan tool, clear the DTC.
瀚慖f the DTC will not clear, replace the module that set the DTC.
2. Ignition OFF, remove the scan tool, open and close the drivers door.
3. Wait 60 seconds, verify DTC B1009 is not set.
瀚慖f the DTC is set, replace the module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming
B1010
DTC B1010
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1010 52
- System Sensors Data Mismatch
Diagnostic Fault Information
Circuit/System Description
The front and rear suspension position sensors provide the headlamp control module with front and rear suspension position information. Each
sensor receives a 5 V reference, signal, and low reference circuits from the headlamp control module. The sensor are connected to the control arms
at the front and rear suspension. As the vehicle travels, the suspension compresses and rebounds moving the suspension position sensor arms. This
causes the signal output of the sensors to change. The headlamp control module compares the information from the front and rear suspension
position sensors and adjusts the headlamp leveling as needed.
