2010 Cadillac CTS Sedan AWD V6-3.6L Page 342
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the auxiliary audio jack harness connector.
2. Ignition ON, test for less than 1 volt between the left auxiliary audio signal terminal 6, to ground.
瀚慖f greater than the specified value, test the circuit for a short to voltage. If the circuit tests normal, replace the radio.
3. Test for less than 1 volt between the right auxiliary audio signal terminal 7, to ground.
瀚慖f greater than the specified value, test the circuit for a short to voltage. If the circuit tests normal, replace the radio.
4. Test for less than 1 volt between the auxiliary audio common signal terminal 5, to ground.
瀚慖f greater than the specified value, test the circuit for a short to voltage. If the circuit tests normal, replace the radio.
5. Ignition OFF, test for infinite resistance from the left auxiliary audio signal terminal 6, to ground.
瀚慖f less than the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the radio.
6. Test for infinite resistance from the right auxiliary audio signal terminal 7, to ground.
瀚慖f less than the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the radio.
7. If all of the circuits test normal, replace the auxiliary audio jack.
B1283
DTC B1283-B1286
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1283 00
- Television Antenna 1 Performance
DTC B1284 00
- Television Antenna 2 Performance
DTC B1285 00
- Television Antenna 3 Performance
DTC B1286 00
- Television Antenna 4 Performance
Circuit/System Description
The TV antenna signal circuits consists of 4 individual coaxial cables that carry the TV signal information received by the TV antenna through the
TV antenna amplifier to the TV antenna module.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
