Saturday, March 6, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 363

2010 Cadillac CTS Sedan AWD V6-3.6L Page 363



* Ignition terminal 4



* Ignition terminal 21



* Ignition terminal 21, X4



瀚慖f greater than specified, test the circuit for a short to voltage.



6. Test for less than 1.0 Ohms between the BCM and the ignition switch on the circuits listed below:



* Ignition terminal 2, X1 and ignition switch terminal 4



* Ignition terminal 21, X1 and ignition switch terminal 3



* Ignition terminal 21, X4 and ignition switch terminal 1



瀚慖f greater than specified, test the circuit for open/high resistance



7. If all circuits test normal, replace the BCM.



Component Testing



Ignition Switch



1. Ignition OFF, disconnect the harness connector at the ignition switch.



2. Verify the resistance between the terminals listed below match for each ignition switch position.



瀚慖f not the specified value, replace the ignition switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.



* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition



Switch/Service and Repair/Ignition and Start Switch Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming



B1380



DTC B1370-B1379, B1380-B1389, or B1440-B1443



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B1370 01



- Device Ignition 1 (ON and START) Circuit Short to Battery



DTC B1370 06



- Device Ignition 1 (ON and START) Circuit Short to Ground or Open



DTC B1380 01



- Device Ignition ACCESSORY Circuit Short to Battery



DTC B1380 06



- Device Ignition ACCESSORY Circuit Short to Ground or Open