2010 Cadillac CTS Sedan AWD V6-3.6L Page 755
The car should not pull in either direction causing the steering wheel to be OFF center while driving straight on a level surface.
Reference Information
Schematic Reference
Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, verify that DTCs U1826, U1827, or C0292 are not set.
瀚慖f any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle)
2. Perform the steering angle sensor calibration procedure. Refer to Steering Angle Sensor Centering (See: Sensors and Switches/Sensors and
Switches - Steering and Suspension/Sensors and Switches - Steering/Steering Angle Sensor/Service and Repair/Procedures).
3. With a scan tool, clear the DTC.
4. Operate the vehicle within the conditions for running the DTC. Verify the DTC does not reset.
瀚慖f the DTC resets, replace the steering angle sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Steering Angle Sensor Replacement (See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and Switches -
Steering/Steering Angle Sensor/Service and Repair/Removal and Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programing
C0750
DTC C0750, C0755, C0760, or C0765 (Without UH3)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0750
- Left Front Low Tire Pressure Sensor
DTC C0755
- Right Front Low Tire Pressure Sensor
