Saturday, February 13, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 79

2010 Cadillac CTS Sedan AWD V6-3.6L Page 79



* Steering wheel module coil connector Stage 2 terminal 3 X3 and SDM terminal 5



瀚慖f not within the specified range, test the control circuit for an open/high resistance.



16. Test for less then 1 ohm between the following low control circuit terminals.



* Steering wheel module coil connector Stage 1 terminal 2 X3 and SDM terminal 8



* Steering wheel module coil connector Stage 2 terminal 4 X3 and SDM terminal 4



瀚慖f not within the specified range, test the circuit for an open/high resistance.



17. If all circuits test normal, replace the SDM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Steering Wheel Inflatable Restraint Module Replacement (See: Restraints and Safety Systems/Air Bag Systems/Air Bag/Service and



Repair/Removal and Replacement/Steering Wheel Inflatable Restraint Module Replacement)



* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/SIR/SRS Wiring Repairs)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming



B0013



DTC B0012 or B0013



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0012 01



- Driver Frontal Deployment Loop Stage 1 Short to Battery



DTC B0012 02



- Driver Frontal Deployment Loop Stage 1 Short to Ground



DTC B0012 04



- Driver Frontal Deployment Loop Stage 1 Open Circuit



DTC B0012 0D



- Driver Frontal Deployment Loop Stage 1 Resistance Above Threshold



DTC B0012 0E



- Driver Frontal Deployment Loop Stage 1 Resistance Below Threshold



DTC B0013 01



- Driver Frontal Deployment Loop Stage 2 Short to Battery



DTC B0013 02



- Driver Frontal Deployment Loop Stage 2 Short to Ground



DTC B0013 04



- Driver Frontal Deployment Loop Stage 2 Open Circuit



DTC B0013 0D



- Driver Frontal Deployment Loop Stage 2 Resistance Above Threshold



DTC B0013 0E



- Driver Frontal Deployment Loop Stage 2 Resistance Below Threshold



Diagnostic Fault Information