2010 Cadillac CTS Sedan AWD V6-3.6L Page 536
B2860 06
The steering column telescope sensor signal voltage is less than 0.2 volt for more than 2 seconds.
B2860 5A
An incorrect steering column telescope sensor signal voltage is seen.
B2860 61
The steering column telescope sensor signal voltage does not change when the telescope actuator is commanded.
B2880 01
The steering column tilt sensor signal voltage is greater than 4.8 volts for more than 2 seconds.
B2880 06
The steering column tilt sensor signal voltage is less than 0.2 volt for more than 2 seconds.
B2880 5A
An incorrect steering column tilt sensor signal voltage is seen.
B2880 61
The steering column tilt sensor signal voltage does not change when the telescope actuator is commanded.
Action Taken When the DTC Sets
Steering column tilt operations are suspended.
Conditions for Clearing the DTC
* A current DTC will clear when the malfunction is no longer present
* A history DTC will clear after 50 malfunction-free ignition cycles.
Reference Information
Schematic Reference
Tilt/Telescoping Steering Column Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Tilt/Telescoping Steering Column
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit
Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for Scan Tool Information
Circuit/System Verification
Ignition ON, actuate the telescope or tilt function through the entire range of travel. The telescope or tilt parameter should display between 0.2 and
4.8 volts.
Circuit/System Testing
Telescope or Tilt Sensor Circuit Malfunction
1. Ignition OFF, disconnect the harness connector X2 at the telescope or tilt actuator.
