2010 Cadillac Truck SRX AWD V6-3.0L Page 202
10. If all circuits test normal, replace the S38 ignition mode switch.
Component Testing
1. Ignition OFF, disconnect the harness at the S38 ignition mode switch.
2. Place a jumper wire between ignition mode switch terminal 4 and ground.
3. Place a fused jumper wire between the circuit terminals of the ignition mode switch listed below and B+:
* Ignition mode switch terminal 2
* Ignition mode switch terminal 5
瀚慖f the either LED does not light, replace the S38 ignition mode switch.
4. Without the button pressed, test for 4,870 ohm between the ignition mode switch terminals listed below:
* Ignition mode switch terminals 3 and 7
* Ignition mode switch terminals 4 and 6
瀚慖f not the specified value, replace the S38 ignition mode switch.
5. With the button pressed, test for 1,300 ohm between the ignition mode switch terminals listed below:
* Ignition mode switch terminals 3 and 7
* Ignition mode switch terminals 4 and 6
瀚慖f not the specified value, replace the S38 ignition mode switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition
Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup
Remote Functions
DTC B097B
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptors
DTC B097B 02
- Power Mode Start Switch Circuit Short to Ground
DTC B097B 05
- Power Mode Start Switch Circuit High Voltage/Open
DTC B097B 08
- Power Mode Start Switch Circuit Performance - Signal Invalid
DTC B097B 61
- Power Mode Start Switch Circuit Stuck
Circuit/System Description
Note: Depending on the vehicle build date and BCM software level, the method to place the vehicle in the run mode will be different. Early
vehicles that have not had the BCM replaced or reprogrammed will require two presses of the igniting mode switch to enter run mode. Late
vehicles and vehicles that have had the BCM replaced or reprogrammed require the ignition mode switch be pressed and held for 5 seconds to enter
