2010 Cadillac Truck SRX AWD V6-3.0L Page 643
The BCM detects short to ground in the unlock signal circuit for greater than 60 seconds.
B3150 00
The BCM detects a short to ground in the lock signal circuit for greater than 60 seconds.
Action Taken When the DTC Sets
The door lock switch will malfunction.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Door Lock/Indicator Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Door Lock/Indicator Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Power Door Locks Description and Operation (See: Body and Frame/Locks/Power Locks/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool BCM Central Door Lock Switch on Console parameter. The reading should be Inactive and change to Lock and
Unlock when pushing the appropriate switch.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the A20 radio/HVAC control.
2. Ignition ON, verify the scan tool Central Door Lock Switch on Center Console parameter is Inactive.
瀚慖f the value is Lock , test the signal circuit terminal 12 for a short to ground. If the circuit tests normal, replace the K9 BCM.
瀚慖f the value is Unlock , test the signal circuit terminal 13 for a short to ground. If the circuit tests normal, replace the K9 BCM.
3. If all circuits test normal, replace the A20 radio/HVAC control.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM and HVAC control replacement, setup and
programming
B3150
DTC B3140 or B3150
Diagnostic Instructions
