2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2737
6. If equipped, ignition ON, verify that a test lamp illuminates between the communication enable circuit terminal OR the accessory wakeup
circuit terminal and ground.
瀚慖f the test lamp does not illuminate, test the circuit for an open/high resistance. If the circuits test normal, replace the BCM.
7. Ignition OFF for 60 seconds, test for less than 5 ohm between the serial data circuit terminals and the appropriate DLC terminal listed below:
* Class 2 serial data circuit terminal 2
* Low speed GMLAN serial data terminal 1
* High speed GMLAN serial data terminal 6 or 14
瀚慖f greater than the specified range, test the serial data circuit for an open/high resistance between the non communicating control module
and a control module setting the DTC or a serial data splice pack.
8. If all circuits test normal, replace the control module that is not communicating.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* GMLAN Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Wiring Repairs/GMLAN Wiring Repairs)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and
programming
C126C, C126D, C12E3, or U180F
DTC C126C, C126D, C12E3, or U180F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C126C
- Control Module Communication Bus B Off
DTC C126D
- Control Module Communication Bus B Off
DTC C12E3
- Control Module Communication Bus B Off
DTC U180F
- Control Module Communication Bus B Off
Circuit/System Description
The PTLAN serial data circuits are serial data buses used to communicate information between the control modules. The PTLAN serial data
circuits also connect directly to the data link connector (DLC) for programming purposes. If this serial data system is inoperative the modules will
still communicate with the scan tool due to other serial data systems but not with each other. Communication with the scan tool for the modules on
the PTLAN bus is through the serial data gateway module (SDGM) on the HSGMLAN serial data system.
Conditions for Running the DTCs
* Supply voltage to the modules are in the normal operating range.
* The ignition switch in any position other than START.
Conditions for Setting the DTC
The module setting the DTC has attempted to establish communications on the PTLAN serial data circuits more than 3 times.
