2010 Cadillac CTS Sedan AWD V6-3.6L Page 353
* Terminal S X1 (RCDLR EK2)
* Terminal 19 (TVM)
* Terminal 16 X2, Pedestrian impact detection module
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
3. Verify that a test lamp illuminates between the B+ circuit terminals listed below and ground.
* Terminal 4 X1 (AMP)
* Terminal 44 X1 (Radio)
* Terminal 18 X1 (HVAC)
* Terminal 19 (IPC)
* Terminal 1 X1 (RPA)
* Terminal 9 (SDM)
* Terminal 17(SDM)
* Terminal A (PPS)
* Terminal H X1 (RCDLR EK2)
* Terminal 20 (TVM)
* Terminal 15 X2, Pedestrian impact detection module
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
4. If the circuits test normal, replace the appropriate control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning)for the appropriate control module replacement, setup, and
programming
B1335
DTC B1335
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1335 0B
- Device Power 3 Circuit Current Above Threshold
DTC B1335 42
- Device Power 3 Circuit Calibration Data Set Not Programed
DTC B1335 4B
- Device Power 3 Circuit Calibration Not Learned
Diagnostic Fault Information
