2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2147
Circuit/System Verification
Note: This DTC may be stored as a history DTC without affecting the operation of the module. If stored only as a history DTC and not retrieved as
a current DTC, do not replace the module.
1. Verify that DTC P0602 is not set.
瀚慖f the DTC is set, program the K27 fuel pump control module.
2. Verify that DTCs P0601, P0603, P0604, P0606, and P062F are not set.
瀚慖f the DTCs are set, program the K27 fuel pump control module. If the DTCs reset, replace the K27 fuel pump control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning)for fuel pump control module replacement, setup, and
programming
ECM
DTC P0601, P0602, P0603, P0604, P0606, P0607, P060D, P062F, or P2610 (ECM)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each of the diagnostic category.
DTC Descriptors
DTC P0601
- Control Module Read Only Memory Performance
DTC P0602
- Control Module Not Programmed
DTC P0603
- Control Module Long Term Memory Reset
DTC P0604
- Control Module Random Access Memory Performance
DTC P0606
- Control Module Processor Performance
DTC P0607
- Control Module Performance
DTC P060D
- Control Module Accelerator Pedal (APP) Position System Circuitry Performance
DTC P062F
- Control Module Long Term Memory Performance
DTC P2610
- Control Module Ignition Off Timer Performance
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM) and the throttle actuator control
(TAC) system. This diagnostic also addresses if the ECM is not programmed.
The ECM monitors its ability to read and write to the memory. It also monitors a timing function. The ECM and the TAC processors are used to
