Sunday, November 1, 2020

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1779

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1779

- Throttle Position (TP) Sensor 1-2 Correlation

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The throttle body assembly contains 2 throttle position (TP) sensors. The TP sensors are mounted to the throttle body assembly and are not

serviceable. The TP sensors provide a signal voltage that changes relative to throttle blade angle. The engine control module (ECM) supplies the TP

sensors with a common 5 V reference circuit, a common low reference circuit, and two independent signal circuits.

The TP sensors have opposite functionality. TP sensor 1 signal voltage decreases and TP sensor 2 signal voltage increases as the accelerator pedal

increases to wide open throttle (WOT).

Conditions for Running the DTC

* DTC P0641 or P0651 is not set.

* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.

* The ignition is ON or the engine is operating.

* DTC P0120, P0122, P0123, P0220, P0222, P0223, P2135 run continuously when the above conditions are met.

Conditions for Setting the DTC

P0120

TP sensor 1 voltage is less than 0.325 V or greater than 4.75 V for greater than 1 s.

P0122

The ECM detects that the TP sensor 1 voltage is less than 0.325 V for greater than 1 s.

P0123

The ECM detects that the TP sensor 1 voltage is greater than 4.75 V for greater than 1 s.