2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2296
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control solenoid valve assembly replacement. Refer to Control Module References (See: Testing and Inspection/Programming and
Relearning) for replacement, setup, and programming.
* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Programming and Relearning) following all transmission related repairs.
2ML70 - Automatic Transmission
DTC P0776 or P0777
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0776
- Pressure Control (PC) Solenoid 2 - Stuck OFF
DTC P0777
- Pressure Control (PC) Solenoid 2 - Stuck ON
Circuit/System Description
The clutch pressure control solenoid 2 is part of the control solenoid valve assembly and is not serviced separately. The clutch pressure control
solenoid 2 controls transmission fluid pressure to the hybrid direct, 2-3-4 clutch regulator valve. The transmission control module monitors the
transmission fluid pressure switch 3 state, in order to determine function of the clutch pressure control solenoid 2 and the hybrid direct, 2-3-4 clutch
regulator valve. When the clutch pressure control solenoid 2 is commanded ON, the transmission fluid pressure switch 3 state should be High.
When the clutch pressure control solenoid 2 is commanded Off, the transmission fluid pressure switch 3 parameter state should be Low.
Conditions for Running the DTC
P0776 or P0777
* The engine run time is greater than 1 second.
* Shift solenoid valve 1 is not in a transition state.
