2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2474
Conditions for Running the DTC
P1516 and P2101
* DTC P0606 and P1682 is not set.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The engine is running or the following conditions are met:
- The engine is not running.
- The ignition voltage is greater than 11 V.
- The TAC system is not in the Battery Saver mode.
- The ECM is commanding the throttle.
- The ECM has learned the minimum throttle position.
* DTC P1516 and P2101 run continuously when the above conditions are met.
P2119
* The ignition is ON.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The TP sensor 1 voltage is greater than 1.7 V
* The ECM is not commanding the throttle blade.
* DTC P2119 runs continuously when the above conditions are met.
P2176
* DTCs P0120, P0121, P0122, P0123, P0220, P0222, P0223, or P1682 is not set.
* The ignition is ON.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The ECM enable the minimum throttle learn procedure.
* DTC P2176 run continuously when the above conditions are met.
Conditions for Setting the DTC
P1516
The actual throttle position does not match the predicted throttle position for greater than 1 s.
P2101
The actual throttle position does not match the predicted throttle position for greater than 1 s.
P2119
The ECM detects that the throttle blade did not return to the default position when the TAC motor is de-energized for greater than 1 s.
P2176
The ECM detects that both throttle position (TP) sensors were greater than a predetermined voltage during the minimum throttle learn procedure for
greater than 2 s.
Action Taken When the DTC Sets
P1516, P2101, and P2176
* DTCs P1516, P2101, and P2176 are Type A DTCs.
* The control module commands the TAC system to operate in the Reduced Engine Power mode.
* A message center or an indicator displays Reduced Engine Power.
* Under certain conditions, the control module commands the engine OFF.
P2119
* DTC P2119 is a Type C DTC.
* The driver information center, if equipped, may display a message.
Conditions for Clearing the MIL/DTC
* DTCs P1516, P2101, and P2176 are Type A DTCs.
* DTC P2119 is a Type C DTC.
Diagnostic Aids
* If the Throttle Sweep Test is not available on the scan tool, observe the scan tool TAC Motor parameter while performing the following tests:
