2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1797
DTC P0054
- HO2S Heater Resistance Bank 1 Sensor 2
DTC P0056
- HO2S Heater Control Circuit Bank 2 Sensor 2
DTC P0059
- HO2S Heater Resistance Bank 2 Sensor 1
DTC P0060
- HO2S Heater Resistance Bank 2 Sensor 2
DTC P0135
- HO2S Heater Performance Bank 1 Sensor 1
DTC P0141
- HO2S Heater Performance Bank 1 Sensor 2
DTC P0155
- HO2S Heater Performance Bank 2 Sensor 1
DTC P0161
- HO2S Heater Performance Bank 2 Sensor 2
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
Heated oxygen sensors (HO2S) are used for fuel control and post catalyst monitoring. Each HO2S compares the oxygen content of the surrounding
air with the oxygen content in the exhaust stream. The HO2S must reach operating temperature to provide an accurate voltage signal. A heating
element inside the HO2S minimizes the time required for the sensors to reach operating temperature. Voltage is provided to the heater by an
ignition voltage circuit through a fuse. With the engine running, ground is provided to the heater by the HO2S heater low control circuit through a
low side driver within the engine control module (ECM). The ECM uses pulse width modulation (PWM) to control the HO2S heater operation to
maintain a specific HO2S operating temperature range.
Conditions for Running the DTC
P0030, P0036, P0050, or P0056
* The ignition 1 voltage is between 11-18 volts.
* The engine speed is greater than 400 RPM.
* The DTCs run continuously when the above conditions are met for 1 second.
P0053, P0054, P0059, or P0060
* DTCs P0112, P0113, P0117, P0118, or P2610 are not set.
