2010 Cadillac Truck SRX AWD V6-3.0L Page 818
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The DTC is not detected in 40 consecutive ignition cycles.
Reference Information
Schematic Reference
Rear Axle Schematics (See: Transmission and Drivetrain/Differential Assembly/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Rear Drive Axle Description and Operation (See: Transmission and Drivetrain/Differential Assembly/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Engine running, observe the scan tool Rear Drive Clutch Status parameter. The scan tool should display TEMPORARILY LIMITED when
stationary.
Circuit/System Testing
Important: The rear drive clutch solenoid valve is calibrated with and is part of the rear differential clutch control module. Both
components must be replaced as a matched set.
1. Ignition OFF, replace the oil filter in the torque transfer device housing.
2. Drive the vehicle under normal operating conditions.
3. Verify DTC C0403 62 is not set.
瀚慖f the DTC is set, replace the K47 rear differential clutch control module/Q48 rear drive clutch solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Differential Clutch Oil Filter Replacement (See: Transmission and Drivetrain/Differential Assembly/Differential Clutch/Service and
Repair/Differential Clutch Oil Filter Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for rear differential clutch control module
replacement, setup, and programming
C0406
DTC C0406
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
