2010 Cadillac Truck SRX AWD V6-3.0L Page 539
DTC B2430 0D
- Passenger Seat Cushion Heater Circuit High Resistance
DTC B2430 0E
- Passenger Seat Cushion Heater Circuit Low Resistance
Diagnostic Fault Information
Circuit/System Description
The driver and front passenger heated seats are controlled by the seat memory control module that is located under the driver seat cushion. When
the heated seat is active, the module applies power through a common voltage supply circuit to the seat heater elements. The module controls the
seat temperature by providing a pulse width modulation (PWM) ground through the seat heater element control circuit to the heater elements. The
module then monitors the current flow through the heating elements and the rate of change of the temperature sensor to verify correct heated seat
operation.
Conditions for Running the DTC
* DTC B1325 must not be present.
* The engine must be running.
* The seat memory control module must be powered and the heated seat must be enabled.
Conditions for Setting the DTC
B2425 0D or B2430 0D
By measuring current and voltage output to the seat heating elements every 10 seconds, the seat memory control module calculates that the heating
element resistance is above the maximum resistance.
B2425 0B, B2425 0E, B2430 0B, or B2430 0E
By measuring current and voltage output to the seat heating elements every 10 seconds, the seat memory control module calculates that the heating
element resistance is below the minimum resistance.
Action Taken When the DTC Sets
The heated seat function for the affected seat will be disabled.
Conditions for Clearing the DTC
* The current DTC clears when the malfunction is no longer present, and the power mode changes to OFF then back to ACC or RUN.
* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.
