2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1758
3. Install a jumper wire between the low reference circuit of the MAP sensor and ground.
4. Install a jumper wire at the MAP sensor signal circuit.
5. Connect a DMM between the jumper wire from the MAP sensor signal circuit and ground.
6. Install the J-35555 to the MAP sensor vacuum port. Slowly apply vacuum to the sensor while observing the voltage on the DMM. The
voltage should vary between 0-5.2 volts without any spikes or dropouts.
瀚慖f the voltage is not within the specified range or is erratic, replace the MAP sensor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Manifold Absolute Pressure Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Manifold
Pressure/Vacuum Sensor/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0112
DTC P0112 or P0113
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0112
- Intake Air Temperature (IAT) Sensor Circuit Low Voltage
DTC P0113
- Intake Air Temperature (IAT) Sensor Circuit High Voltage
Diagnostic Fault Information
Typical Scan Tool Data
Circuit/System Description
The intake air temperature (IAT) sensor, a part of the mass air flow (MAF) sensor assembly, is a variable resistor. The IAT sensor has a signal
circuit and a low reference circuit. The IAT sensor measures the temperature of the air entering the engine. The engine control module (ECM)
supplies 5 V to the IAT signal circuit, and a ground for the IAT low reference circuit.
Conditions for Running the DTC
P0112
* DTCs P0116, P0117, P0118, P0125, P0128, P0722, P0723 are not set.
* The engine is running for greater than 10 s.
* The engine coolant temperature (ECT) is colder than 150掳C (302掳F).
