2010 Cadillac CTS Sedan AWD V6-3.0L Page 1551
* Crankshaft Position Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Crankshaft Position
Sensor/Service and Repair)
* Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement (See: Heating and Air Conditioning/Refrigerant Pressure Sensor /
Switch/Service and Repair)
* Clutch Pedal Position Switch Replacement (See: Powertrain Management/Transmission Control Systems/Sensors and Switches -
Transmission and Drivetrain/Sensors and Switches - M/T/Clutch Pedal Position Sensor / Switch/Service and Repair)
P0643
DTC P0641-P0643, P0651-P0653, or P0697-P0699 (ECM, LLT)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0641
- 5 V Reference 1 Circuit
DTC P0642
- 5 V Reference 1 Circuit Low Voltage
DTC P0643
- 5 V Reference 1 Circuit High Voltage
DTC P0651
- 5 V Reference 2 Circuit
DTC P0652
- 5 V Reference 2 Circuit Low Voltage
DTC P0653
- 5 V Reference 2 Circuit High Voltage
DTC P0697
- 5 V Reference 3 Circuit
DTC P0698
- 5 V Reference 3 Circuit Low Voltage
DTC P0699
- 5 V Reference 3 Circuit High Voltage
Circuit/System Description
The engine control module (ECM) has 3 5 V reference circuits. The ECM provides the 5 V reference to various sensors. Each reference circuit
provides a 5 V reference for more than one sensor. An open, short to ground, or short voltage on one of the 5 V reference circuits can affect all the
components connected to that 5 V reference circuit. The ECM monitors the voltage on the 5 V reference circuits.
Conditions for Running the DTC
* The ignition is ON for more than 3 s.
* DTCs P0641, P0642, P0643, P0651, P0652, P0653, P0697, P0698, and P0699 run continuously when the above condition is met.
Conditions for Setting the DTC
The 5 V reference circuit voltage is greater or less than a predetermined threshold.
Action Taken When the DTC Sets
DTCs P0641, P0642, P0643, P0651, P0652, P0653, P0697, P0698, and P0699 are Type A DTCs.
Conditions for Clearing the DTC
