2010 Cadillac CTS Sedan AWD V6-3.0L Page 1972
DTC P2307
- Ignition Coil 3 Control Circuit High Voltage
DTC P2309
- Ignition Coil 4 Control Circuit Low Voltage
DTC P2310
- Ignition Coil 4 Control Circuit High Voltage
DTC P2312
- Ignition Coil 5 Control Circuit Low Voltage
DTC P2313
- Ignition Coil 5 Control Circuit High Voltage
DTC P2315
- Ignition Coil 6 Control Circuit Low Voltage
DTC P2316
- Ignition Coil 6 Control Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The ignition system on this engine uses individual ignition coils and ignition control (IC) circuits for each cylinder. Ignition voltage is supplied to
each bank of ignition coils. The engine control module (ECM) controls the ignition system operation. The ECM controls each coil using the IC
circuits. The ECM commands the IC circuit low when a spark event is requested.
The sequencing and timing are ECM controlled.
Conditions for Running the DTC
* The engine is operating.
* The ignition voltage is between 10-18 volts.
* The engine speed is less than 6,000 RPM.
* The DTCs run continuously once per crankshaft revolution after the above conditions are met.
Conditions for Setting the DTC
P0351-P0356
The ECM detects the ignition control circuit is open for greater than 4 seconds or a cumulative of 30 seconds.
P2300, P2303, P2306, P2309, P2312, or P2315
The ECM detects the ignition control circuit is shorted to ground for greater than 4 seconds or a cumulative of 30 seconds.
P2301, P2304, P2307, P2310, P2313, or P2316
