2010 Cadillac Truck SRX AWD V6-3.0L Page 1096
to request DTC P069E to be set in the ECM.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
Circuit/System Verification
Note: Correct any engine controls and communication DTCs before diagnosing fuel pump control module DTCs.
1. DTC P069E is an informational DTC. If there are no engine controls or communication DTCs, refer to Diagnostic Trouble Code (DTC) List -
Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for diagnosis of fuel pump control
module DTCs.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
P071A
DTC P071A
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P071A
- Transmission Tow Mode Switch Circuit
Circuit/System Description
Tow/haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the
tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the transmission control module
(TCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again disables tow/haul
mode and returns the transmission to a normal shift pattern.
Conditions for Running the DTC
* No Transmission Mode Switch Signal DTC P1762.
* The engine speed is greater than 500 RPM for 5 seconds.
* The system voltage is 8-18 volts.
Conditions for Setting the DTC
The Tow Mode switch remains closed, low voltage, for 600 seconds.
Action Taken When the DTC Sets
DTC P071A is a Type C DTC.
Conditions for Clearing the DTC
DTC P071A is a Type C DTC.
