Sunday, September 27, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1969

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1969



DTC P2307



- Ignition Coil 3 Control Circuit High Voltage



DTC P2309



- Ignition Coil 4 Control Circuit Low Voltage



DTC P2310



- Ignition Coil 4 Control Circuit High Voltage



DTC P2312



- Ignition Coil 5 Control Circuit Low Voltage



DTC P2313



- Ignition Coil 5 Control Circuit High Voltage



DTC P2315



- Ignition Coil 6 Control Circuit Low Voltage



DTC P2316



- Ignition Coil 6 Control Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The ignition system on this engine uses individual ignition coils and ignition control (IC) circuits for each cylinder. Ignition voltage is supplied to



each bank of ignition coils. The engine control module (ECM) controls the ignition system operation. The ECM controls each coil using the IC



circuits. The ECM commands the IC circuit low when a spark event is requested.



The sequencing and timing are ECM controlled.



Conditions for Running the DTC



* The engine is operating.



* The ignition voltage is between 10-18 volts.



* The engine speed is less than 6,000 RPM.



* The DTCs run continuously once per crankshaft revolution after the above conditions are met.



Conditions for Setting the DTC



P0351-P0356



The ECM detects the ignition control circuit is open for greater than 4 seconds or a cumulative of 30 seconds.



P2300, P2303, P2306, P2309, P2312, or P2315



The ECM detects the ignition control circuit is shorted to ground for greater than 4 seconds or a cumulative of 30 seconds.



P2301, P2304, P2307, P2310, P2313, or P2316