2010 Cadillac Truck SRX AWD V6-3.0L Page 1456
* Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake (See: Powertrain Management/Computers and Control
Systems/Camshaft Position Sensor/Service and Repair/Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0351
DTC P0351-P0356 (LF1)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0351
- Ignition Coil 1 Control Circuit
DTC P0352
- Ignition Coil 2 Control Circuit
DTC P0353
- Ignition Coil 3 Control Circuit
DTC P0354
- Ignition Coil 4 Control Circuit
DTC P0355
- Ignition Coil 5 Control Circuit
DTC P0356
- Ignition Coil 6 Control Circuit
Diagnostic Fault Information
Circuit/System Description
The ignition system on this engine uses an individual coil/module for each cylinder. The engine control module (ECM) controls the spark event for
each cylinder through the eight individual ignition control circuits. When the ECM commands the ignition control circuit ON, electrical current will
flow through the primary winding of the ignition coil, creating a magnetic field. When a spark event is requested, the ECM will command the
ignition control circuit OFF, interrupting current flow through the primary winding. The magnetic field created by the primary winding will
collapse across the secondary coil windings, producing a high voltage across the spark plug electrodes. The ECM uses information from the
crankshaft position sensor, and the camshaft position sensor for sequencing and timing of the spark events.
Conditions for Running the DTC
* The engine is running.
* The ignition voltage is greater than 6 V.
* DTC P0351-P0356 runs continuously when the above conditions are met.
