2010 Cadillac Truck SRX AWD V6-3.0L Page 1539
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Throttle Body Assembly Replacement (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal and Replacement)Throttle Body Assembly Replacement (LAU) (See: Powertrain Management/Fuel Delivery and Air
Induction/Throttle Body/Service and Repair/Removal and Replacement)
P0513
DTC P0513
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC P0513
- Immobilizer Key Incorrect
Circuit/System Description
The body control module (BCM) sends the pre-release information to the engine control module (ECM) via the serial data circuit. The ECM then
sends a challenge to the BCM. Both the ECM and BCM perform a calculation on this challenge. If the calculated response from the BCM equals
the calculation performed by the ECM, the ECM will allow vehicle starting.
Conditions for Running the DTC
Ignition is in the ACCESSORY or RUN position.
Conditions for Setting the DTC
The calculated response from the BCM does not equal the calculation performed by the ECM.
Action Taken When the DTC Sets
* The security indicator in the instrument cluster will illuminate.
* Vehicle starting will be disabled.
Conditions for Clearing the DTC
* A current DTC P0513 will be cleared when a valid calculation is received.
* A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Diagnostic Aids
The key referenced in the DTC descriptor does not refer to the vehicle key. In this case, key is referring to the challenge response.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and
Operation/Immobilizer)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
