2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 196
* The SDM disables the Passenger Airbag Module.
* The PPS will illuminate the Passenger Airbag status OFF indicator.
* The SDM requests the instrument panel cluster (IPC) to illuminate the AIRBAG indicator.
Conditions for Clearing the DTC
* The condition for setting the DTC no longer exists.
* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.
Diagnostic Aids
Inspect the passenger seat belt tension sensor signal, voltage reference, and low reference circuits carefully for cutting and/or chafing.
Reference Information
Schematic Reference
SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
Important: The seat belt buckle replacement with the seat belt tension sensor must be serviced as a complete unit.
When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the
affected component/connector:
* Seat belt tension sensor
* PPS module
* Seat belt tension sensor wiring harness connector
* PPS module wiring harness connector
1. Ignition OFF, disconnect the harness connector at the passenger seat belt tension sensor and inspect the component and harness sides for
damage or corrosion.
瀚慖f damage or corrosion is found, repair or replace as necessary.
2. Ignition ON, test for 4.5-5.5 volts between the passenger seat belt tension sensor voltage reference circuit terminal A X2 and ground.
瀚慖f less that the specified range, test the voltage reference circuit for open/high resistance or a short to ground. If the circuit tests normal,
replace the PPS module.
瀚慖f greater that the specified range, test the voltage reference circuit for a short to voltage. If the circuit tests normal, replace the PPS
module.
3. Ignition OFF, remove the AIR BAG BATT Fuse in the underhood fuse block. Test for less than 2.0 ohms between the passenger seat belt
tension sensor low reference terminal B X2 and ground.
瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the PPS
CADILLAC Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.