2010 Cadillac Truck Escalade RWD V8-6.2L Page 2846
* Front Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Front Side Door Window
Regulator Motor Replacement)
* Rear Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window
Regulator Motor Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for window, and door lock switches (door
modules), window regulator motors, or electronic compass module replacement, setup, and programming
U1513
DTC U1500, U1511, U1512, or U1513
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC U1500 01
- Inter-Device Dedicated Bus 1 Short to Battery
DTC U1500 02
- Inter-Device Dedicated Bus 1 Short to Ground
DTC U1500 31
- Electronic Control Unit (ECU) Performance General Checksum Failure
DTC U1511 00
- Inter-device Dedicated Bus Lost Communication With Device 1
DTC U1512 00
- Inter-device Dedicated Bus Lost Communication With Device 2
Diagnostic Fault Information
Circuit/System Description
The driver door module (DDM) and the front passenger door module (FPDM) communicate with window regulator motors on the local
interconnect network bus 1 and the local interconnect network bus 2 circuits respectively. When the driver power window switch is activated to a
desired position, the DDM examines the request and checks for messages from other vehicle control modules prohibiting window movement. If no
prohibitive messages have been received, the DDM will send a LIN serial data message to the driver door window motor to move the window to
the desired position.
When the DDM receives a request to operate one of the right side passenger windows from the driver master control, a GMLAN serial data
message is sent to the PDM. The PDM examines the request and checks for messages from other vehicle control modules prohibiting the window
movement. If no prohibitive messages have been received, the PDM will send a LIN serial data message to the appropriate window motor to move
the window as requested.
The DDM and PDM supply their respective rear power window switches with a 12 V reference and signal circuit. The rear power window switches
contain separate resistors for each switch position. When a rear power window switch is activated, the associated door control module interprets the
