2010 Cadillac CTS Sedan AWD V6-3.0L Technical Service Bulletin # 09-08-50-012 Date: 090731
Body - Removal Of Front Seat Adjuster Track Covers
INFORMATION
Bulletin No.: 09-08-50-012
Date: July 31, 2009
Subject: Proper Removal of Front Seat Adjuster Track Finish Covers For Any Related Service Repairs
Models:
2007-2010 Cadillac CTS, CTS-V
Attention:
The purpose of this bulletin is to provide detail regarding the proper removal of the front seat adjuster track finish covers for any related service
repairs. Following the steps outlined below will help eliminate the likelihood of breaking or damaging the seat finish covers.
Remove the front (1) or rear (2) front seat adjuster track finish covers following the information and steps below:
Note
2010 Cadillac CTS Sedan AWD V6-3.0L Page 190
When installed to the seat adjuster track, the front finish covers are engaged at the locations noted on the underside view above:
- On the inboard side, the finish cover hook (1) attaches behind the front adjuster hook.
- The forward tab (2) is secured underneath the front of the adjuster rail.
- On the outboard side, the rearward tab (3) sits behind the front adjuster hook.
Note
When installed to the seat adjuster track, the rear finish covers are engaged at the locations noted on the underside view above:
- The two rearward finish cover clips (1) are engaged to the adjuster track.
- The forward finish cover hook (2) is engaged in the slot in the adjuster lower bracket.
To remove the front seat adjuster track front finish covers:
1. Disengage the outboard side of the cover by pulling it outward, flexing the cover tab away from the adjuster hook.
2. When the tab is clear of the hook, pull the front of the cover up and forward to release it from the front of the adjuster rail.
3. After the front tab comes free, then disengage the hook on the inboard side of the cover.
Tip
Use the same method to remove the opposite side.
To remove the front seat adjuster track rear finish covers:
1. Disengage the two rear cover clips by prying the cover upward from the rear of the cover.
2. When the clips are free from the adjuster track, pull the cover rearward to disengage the hook from the adjuster lower bracket.
Tip
Use the same method to remove the opposite side.
