2010 Cadillac CTS Sedan AWD V6-3.0L Page 1763
P1516
DTC P1516, P2101, P2119, or P2176 (LF1)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P1516
- Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance
DTC P2101
- Throttle Actuator Position Performance
DTC P2119
- Throttle Closed Position Performance
DTC P2176
- Minimum Throttle Position Not Learned
Diagnostic Fault Information
Circuit/System Description
The engine control module (ECM) controls the throttle valve by applying a varying voltage to the control circuits of the throttle actuator control
(TAC) motor. The ECM monitors the duty cycle that is required to actuate the throttle valve. The ECM monitors the throttle position (TP) sensors 1
and 2 to determine the actual throttle valve position.
Conditions for Running the DTC
P1516 and P2101
* DTC P1682 is not set.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The engine is running or the following conditions are met:
- The engine is not running.
- The ignition voltage is greater than 11 V.
- The TAC system is not in the Battery Saver mode.
- The ECM is commanding the throttle.
- The ECM has learned the minimum throttle position.
* DTC P1516 and P2101 run continuously when the above conditions are met.
P2119
* The ignition is ON.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The system is in the Battery Save mode.
* DTC P2119 runs continuously when the above conditions are met.
P2176
* DTCs P0068, P0122, P0123, P0222, P0223 are not set.
* The ignition is ON.
* The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
* The system is not in the Battery Save mode.
* DTC P2176 runs continuously when the above conditions are met.
