2010 Cadillac Truck SRX AWD V6-3.0L Page 748
The appropriate rear turn signal will be inoperative.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
Circuit/System Verification
1. Ignition ON, command the Left Rear Turn Signal Lamp ON and OFF with a scan tool. The left rear turn signal lamp should turn ON and
OFF when changing between the commanded states.
2. Command the Right Rear Turn Signal Lamp ON and OFF with a scan tool. The right rear turn signal lamp should turn ON and OFF when
changing between the commanded states.
Circuit/System Testing
1. Ignition OFF, disconnect the X2 harness connector K9 BCM.
2. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance
3. Ignition OFF, connect the X2 harness connector K9 BCM.
4. Ignition OFF, disconnect the X2 harness connector at the appropriate E4 turn signal lamp-rear.
5. Test for less than 30 ohm between the ground circuit terminal 1 and ground.
瀚慖f greater than the specified value, test the ground circuit for an open/high resistance.
6. Connect a test lamp between the control circuit terminal 3 and ground.
7. Command the appropriate Rear Turn Signal Lamp ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing
between the commanded states.
瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.
瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the K9 BCM.
8. If all the circuits test normal, replace the bulb or E4 turn signal lamp-rear.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Rear Turn Signal Lamp Bulb Replacement (See: Lighting and Horns/Turn Signals/Turn Signal Lamp/Turn Signal Bulb/Service and
Repair/Rear Turn Signal Lamp Bulb Replacement)
