Friday, July 10, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 790

2010 Cadillac Truck SRX AWD V6-3.0L Page 790



瀚慖f the DTC resets, replace the K17 Electronic Brake Control Module (EBCM).



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic



Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure Modulator Valve Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, programming and setup



C0131



DTC C0131



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC C0131 00



- Traction Control System Pressure Circuit Malfunction



DTC C0131 5A



- Traction Control System Pressure Circuit Not Plausible



Diagnostic Fault Information



Circuit/System Description



The brake pressure sensor is integral to the brake pressure modulator valve assembly. The electronic brake control module (EBCM) monitors the



brake pressure sensor supply voltage and the signal voltage. The body control module (BCM) sends a serial data message when the brake pedal is



applied.



Conditions for Running the DTC



Ignition ON.



Conditions for Setting the DTC



C0131 00



The brake pressure sensor signal is out of the specified range.



C0131 5A



* The EBCM detected an invalid or erratic brake pressure sensor signal.



* The brake pressure sensor signal is not plausible.



* The brake pressure sensor signal offset is out of specified range.



Action Taken When the DTC Sets



* The EBCM disables the traction control and stability control for the duration of the ignition cycle.



* The traction control/stability control-active indicator turns ON.



Conditions for Clearing the DTC



* A current DTC clears when the diagnostic runs and passes.



* The EBCM will turn OFF the indicator in the next ignition cycle.