2010 Cadillac Truck Escalade RWD V8-6.2L Page 2581
When attempting to set solenoid electrical DTCs, ensure the TCM is warmed up and the transmission is operated long enough to ensure a 3掳C (5掳F)
increase in TCM temperature parameter. This will place the transmission control module in the optimal conditions to test solenoid electrical DTCs.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Circuit/System Verification
1. Engine ON, verify the transmission fluid temperature is between 50-80掳C (122-176掳F).
2. Operate the vehicle long enough to verify at least a 3掳C (5掳F) rise in the TCM temperature parameter, then operate the vehicle in Park for 5
seconds.
3. Engine ON, observe the scan tool Clutch PC 5 Sol. CKT Status parameter. The reading should display OK or Indeterminate.
瀚慖f the reading is not within the specified range, replace the Q8 control solenoid valve assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly replacement,
setup, and programming.
6L50/6L80/6L90 - Automatic Transmission
DTC P2728-P2730
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P2728
- Clutch Pressure Control (PC) Solenoid 5 System Performance
DTC P2729
- Clutch Pressure Control (PC) Solenoid 5 Control Circuit Low Voltage
DTC P2730
- Clutch Pressure Control (PC) Solenoid 5 Control Circuit High Voltage
Diagnostic Fault Information
