2010 Cadillac Truck Escalade RWD V8-6.2L Page 2033
* The ECM detects that the engine is running, but does not receive a camshaft position sensor pulse for 800 of 1000 engine cycles.
Action Taken When the DTC Sets
* DTC P0340 is a Type B DTC.
* The camshaft position actuator if equipped is commanded to the parked position.
* The ignition system defaults to a failed camshaft position sensor limp home mode.
Conditions for Clearing the DTC
DTC P0340 is a Type B DTC.
Diagnostic Aids
* With a DTC set, the engine may crank for an extended period of time during start-up.
* This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test (See:
Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).
Reference Information
Schematic Reference
Engine Controls Schematics (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Electronic Ignition System Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Electronic
Ignition System Description)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Special Tools
J 35616-A/BT-8637 Connector Test Adapter Kit
Circuit/System Verification
1. Engine idling, observe the scan tool Camshaft Position Active Counter parameter. The parameter should be incrementing.
2. Engine idling, observe the DTC information with a scan tool. DTC P0340 should not set.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the B23 camshaft position sensor.
2. Ignition OFF and all vehicle systems OFF, it may take 2 minutes for all vehicle systems to power down, test for less than 1 ohm on the
camshaft position low reference circuit, terminal B, and ground.
瀚慖f greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20
ECM.
3. Ignition ON, test for 4.8-5.2 V between the camshaft position 5 V reference circuit terminal A and ground.
瀚慖f less than the specified range, test the 5 V reference circuit for an open/high resistance or short to ground. If the circuit tests normal,
