Tuesday, July 7, 2020

2010 Cadillac Truck Escalade RWD V8-6.2L Page 2176

2010 Cadillac Truck Escalade RWD V8-6.2L Page 2176

Conditions for Running the DTC

* The control solenoid valve assembly runs the program to detect an internal fault when the key is ON or the engine is running.

* Ignition voltage is 8-18 V.

Conditions for Setting the DTC

The control solenoid valve assembly has detected an internal malfunction.

Action Taken When the DTC Sets

* DTCs P0601, P0602, P0603, P0604, P0606, P060B and P062F are Type A DTCs.

* The transmission control module shifts to a default gear and turns OFF.

Conditions for Clearing the DTC

DTCs P0601, P0602, P0603, P0604, P0606, P060B and P062F are Type A DTCs.

Diagnostic Aids

When attempting to set transmission control module internal DTCs, run the engine for at least 1 minute, and then shut the engine off for 30

seconds. Following this procedure will allow for a complete transmission control module shutdown.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

Verify that DTC P0601, P0602, P0603, P0604, P0606, P060B, or P062F is not set.

If the DTC is set, program the Q8 control solenoid valve assembly. If the DTC resets, replace the Q8 control solenoid valve assembly.

Component Testing

Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic Transmission/Control Solenoid

Valve and Transmission Control Module Assembly Inspection).

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming.

6L45/6L50/6L80/6L90 - Automatic Transmission

DTC P0601-P0604 or P062F