2010 Cadillac Truck Escalade RWD V8-6.2L Page 2002
not stored in the ECM memory, or a proper ECM power down does not occur after completing the CKP Learn Procedure, then DTC P0315 sets.
Conditions for Running the DTC
The diagnostic runs continuously.
Conditions for Setting the DTC
The ECM detects that the CKP system variation values are not stored in memory.
Action Taken When the DTC Sets
DTC P0315 is a Type A code.
Conditions for Clearing the MIL/DTC
DTC P0315 is a Type A code.
Diagnostic Aids
This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test (See:
Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery Inspection/Test).
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
Important: The CKP System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned.
1. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn (See: Powertrain
Management/Computers and Control Systems/Crankshaft Position Sensor/Testing and Inspection).
2. If the CKP System Variation Learn Procedure cannot be performed successfully, inspect for the following conditions:
* Any worn crankshaft main bearings
* A damaged or misaligned reluctor wheel
* Excessive crankshaft runout
* A damaged crankshaft-Refer to Crankshaft and Bearing Cleaning and Inspection (See: Engine, Cooling and Exhaust/Engine/Service and
Repair/Overhaul/35. Crankshaft and Bearing Cleaning and Inspection).
* Interference in the signal circuit of the CKP sensor
* The ignition switch is left in the ON position, until the battery is discharged
* An ECM power disconnect, with the ignition ON, that may have erased the CKP system variation values and set DTC P0315
* Any debris between the CKP sensor and the reluctor wheel
瀚慖f the ECM is still unable to complete the learn procedure, replace the ECM.
Repair Instructions
* Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P0324
DTC P0324, P0325, P0326, P0327, P0328, P0330, P0332, or P0333
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
CADILLAC Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.