Monday, June 8, 2020

2010 Cadillac Truck Escalade RWD V8-6.2L Page 1487

2010 Cadillac Truck Escalade RWD V8-6.2L Page 1487

Important: Removal of the HV manual disconnect lever also opens the HVIC source circuit between X350 and BECM connector X1.

If the circuit tests normal, perform the High Voltage Disabling () procedure and test the HVIC Source circuit for a short to voltage between X350

and BECM connector X1. If the circuit tests normal, replace the BECM.

4. Ignition ON, test for less than 35 mA with a DMM between the HVIC Return circuit terminal 1 and ground.

瀚慖f more than the specified range, test the HVIC Return circuit for a short to voltage between PIM connector X1 and X350.

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal

Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

* Identify how to disable high voltage.

* Identify how to test for the presence of high voltage.

* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures

must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.

If the circuit tests normal, perform the High Voltage Disabling () procedure and test the HVIC Return circuit for a short to voltage between X350

and BECM connector X1. If the circuit tests normal, replace the BECM.

5. If all circuits test normal, replace the PIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM or BECM replacement, setup, and programming

P1AE3

DTC P1AE2-P1AE4, P1B05, or P1B06

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P1AE2

- Battery Energy Control Module High Voltage System Interlock Circuit

DTC P1AE3

- Battery Energy Control Module High Voltage System Interlock Circuit Low Voltage

DTC P1AE4

- Battery Energy Control Module High Voltage System Interlock Circuit High Voltage

DTC P1B05

- Drive Motor 1 Control Module High Voltage System Interlock Circuit

DTC P1B06

- Drive Motor 2 Control Module High Voltage System Interlock Circuit

Diagnostic Fault Information