2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1389
DTC P0496 is a Type B DTC.
Reference Information
Schematic Reference
Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics
(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Evaporative Emission Control System Description (See: Powertrain Management/Computers and Control Systems/Description and
Operation/Evaporative Emission Control System Description)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Troubleshooting with a Test Lamp (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Circuit Testing/Troubleshooting with a Test Lamp)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
1. Ignition ON, engine OFF, seal the EVAP system using the Purge/Seal function with a scan tool.
2. Start the engine.
3. Observe the fuel tank pressure sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90
seconds.
瀚慖f the Fuel Tank Pressure Sensor parameter is greater than the specified range, go to Circuit/System Testing.
4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed
from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Ignition ON, engine OFF.
2. Seal the EVAP system using the Purge/Seal function with a scan tool.
3. Start the engine.
4. Observe the fuel tank pressure sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90
seconds.
瀚慖f the Fuel Tank Pressure Sensor parameter is greater than the specified range, replace the Q12 EVAP canister purge solenoid valve.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Evaporative Emission Canister Purge Solenoid Valve Replacement (LF1) (See: Powertrain Management/Emission Control Systems/Evaporative
Emissions System/Canister Purge Solenoid/Service and Repair)Evaporative Emission Canister Purge Solenoid Valve Replacement (LAU) (See:
Powertrain Management/Emission Control Systems/Evaporative Emissions System/Canister Purge Solenoid/Service and Repair)
P0498
DTC P0449, P0498, or P0499 (LAU)
Diagnostic Instructions
