2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1856
* The ECM detects that the BARO sensor signal is less than 45 kPa (6.5 psi) for 2 s
P2229
* The ECM detects that the BARO sensor voltage is greater than 4.8 V for 0.5 s.
OR
* The ECM detects that the BARO sensor signal is greater than 115 kPa (16.7 psi) for 2 s.
Action Taken When the DTC Sets
DTCs P2227, P2228, and P2229 are Type B DTCs.
Conditions for Clearing the MIL/DTC
DTCs P2227, P2228, and P2229 are Type B DTCs.
Reference Information
Schematic Reference
Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics
(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Start the engine. Observe the DTC information with a scan tool. DTCs P2227, P2228, or P2229 should not set.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Inspect the atmospheric vent on the K20 ECM case for one of the following conditions:
* Moisture in the vent inlet
* Debris in the vent inlet
瀚慖f a condition exists, attempt to clean or dry the atmospheric inlet.
2. Start the engine. Observe the DTC information with a scan tool. DTCs P2227, P2228, or P2229 should not set.
瀚慖f DTC P2227, P2228, or P2229 sets, replace the K20 ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P2228
DTC P2227, P2228, or P2229 (LAU)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
