2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 524
* Control Module References (See: Testing and Inspection/Programming and Relearning) for rear seat heating control module replacement,
setup and programming
B2355
DTC B1825, B2355, B2365, or B2375
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1825 01
- Driver Seat Recline Position Sensor Circuit Short to Battery
DTC B1825 06
- Driver Seat Recline Position Sensor Circuit Low Voltage/Open
DTC B2355 01
- Driver Seat Front Vertical Position Sensor Circuit Short to Battery
DTC B2355 06
- Driver Seat Front Vertical Position Sensor Circuit Low Voltage/Open
DTC B2365 01
- Driver Seat Rear Vertical Position Sensor Circuit Short to Battery
DTC B2365 06
- Driver Seat Rear Vertical Position Sensor Circuit Low Voltage/Open
DTC B2375 01
- Driver Seat Assembly Horizontal Position Sensor Circuit Short to Battery
DTC B2375 06
- Driver Seat Assembly Horizontal Position Sensor Circuit Low Voltage/Open
Diagnostic Fault Information
Circuit Description
The seat memory control module monitors the position of the seat motors by using hall effect position sensors which are an internal part of each
motor. The module supplies each sensor with a 12 V reference circuit and a low side signal circuit. During seat motor operation, the hall effect
position sensor provides a determined number of pulse signals for every revolution of the motor shaft. The scan tool displays these pulse signals as
counts that range from 0 - 65,535. The module counts the feedback pulses from each sensor to determine seat position and end of travel limits for
each of the seat motors. High scan tool count values indicate forward or upward seat positions while low count values indicate rearward or
downward seat positions.
Conditions for Running the DTC
* DTC B1325 must not be present.
