2010 Cadillac CTS Sedan AWD V6-3.6L Page 1538
2. Ignition ON, observe the DTC information with a scan tool.
瀚慖f DTC P0602, P0610, or P0630 failed this ignition, program the K20 ECM. If the DTC resets, replace the K20 ECM.
3. Observe the DTC information with a scan tool. DTC P0601, P0603, P0604, P0606, P0607, P062B, P062F, P16F3, or P2610 should not set.
瀚慖f a DTC failed this ignition, replace the K20 ECM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and
programming
With Y41
DTC P0633 (with Y41)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0633
- Theft Deterrent Key Not Programmed
Circuit/System Description
When learning the prerelease password, as well as the challenge and response sequence, the engine control module (ECM) is placed in learn mode.
DTC P0633 will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the password and
challenge/response are learned, learn mode will be exited when the engine is successfully started. If the ECM does not exit learn mode, P0633 will
remain current and indicate a fault.
Conditions for Running the DTC
The ECM is in learn mode.
Conditions for Setting the DTC
DTC P0633 will set any time the ECM enters learn mode.
Action Taken When the DTC Sets
The security indicator will illuminate.
Conditions for Clearing the DTC
* A current DTC P0633 will be cleared upon a successful engine start after exit of learn mode.
* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Diagnostic Aids
The "key" referenced in the DTC descriptor does not refer to the vehicle key. In this case, "key" is referring to the challenge response.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
