2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 754
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
Circuit/System Verification
Ignition ON, observe the scan tool EBCM Wheel Speed Sensor parameters. The parameters displayed should be within 1.6 km/h (1 MPH) on all
sensors when driving in a straight line at a speed greater than 20 km/h (13 MPH).
Circuit/System Testing
1. Ignition ON, verify that DTC C0035, C0040, C0045, or C0050 is not present in the K17 EBCM.
瀚慖f any listed DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code
Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).
2. Replace the K19 Suspension Control Module and verify the DTC does not reset.
瀚慖f the DTC resets, replace the K17 electronic brake control module (EBCM).
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming.
C019B
DTC C0186, C0196, C019B, or C0287
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0186 5A
- Lateral Acceleration Sensor Circuit Not Plausible
DTC C0186 71
- Lateral Acceleration Sensor Circuit Invalid Data
DTC C0196 00
- Yaw Rate Circuit Malfunction
DTC C0196 5A
- Yaw Rate Signal Not Plausible
DTC C019B 5A
- Yaw Rate Signal Not Plausible
DTC C0287 4B
- Longitudinal Acceleration Sensor Circuit Calibration Not Learned
